Commercial Storm Damage Roofing in Houston

Storm Damage Commercial Roofs Face in Houston

Houston’s wind, hail, and heavy rain affect TPO, PVC, modified bitumen, and metal roofs differently. Some damage is visible from the roof surface. Some is not.

Punctures and Membrane Tears from Wind-Borne Debris

Flying branches, loose rooftop materials, and construction debris can puncture a membrane (the waterproof surface layer). During a first walkthrough from a safe location, look for debris near drains and stained ceiling tiles below.

Hail Impact and Loss of Reflective Coating

Hail can bruise a membrane, stress seams, and wear down the reflective surface without leaving an obvious hole. Documenting these conditions early supports insurance review and manufacturer warranty requirements.

Edge Metal and Flashing Lift in High Winds

Edge metal and flashing (the metal pieces that seal roof perimeters and transitions) are common uplift points in strong gusts. Once they lift, water can quickly reach the roof deck. Gulf Coast humidity and salt air can also corrode these components over time, which makes them easier for the wind to catch.

Hidden Moisture Intrusion That Shows Weeks Later

Water trapped under a membrane can saturate insulation and surface as interior damage long after the storm. We use infrared scanning and core sampling to confirm where moisture is present rather than guessing.

What to Do in the First 24 Hours to Limit Interior Loss

Safety comes first, then protecting your assets and operations.

Shut Off Power in Wet Ceiling Zones

If water is near lighting, panels, or equipment, shut off power to that area when it is safe to do so. Call a licensed electrician for anything involving an electrical panel.

Cover Equipment and Inventory

Move or cover computers, machinery, stock, and tenant contents with plastic sheeting. Place buckets under active drips and keep walkways clear.

Call for Emergency Tarps and Temporary Drains

Tarps and temporary drains control active leaks until permanent repairs begin. We offer 24/7 emergency support to help stabilize your roof and limit further interior damage.

Document Damage with Time-Stamped Photos

Photograph ceilings, floors, and affected equipment. Photograph the roof only if access is safe. Take wide and close-up shots with time stamps on. This supports claim review and gives us a clear starting record.

Our Inspection and Documentation Process for Insurance Claims

HAAG certification means our inspectors have completed training to identify and document storm damage to roofing materials. We use that training to give adjusters clear, verifiable information.

HAAG-Certified Surface Walk and Core Sampling

A HAAG Certified inspector walks the roof, records conditions, and takes small core samples when needed to check for wet insulation or substrate (the layer beneath the membrane) problems.

Infrared Scan to Trace Trapped Moisture

Infrared imaging reveals moisture patterns that are not visible on the surface. Results guide targeted repairs and can limit unnecessary tear-off.

Photo Report and Repair Scope Formatted for Adjusters

Our reports include photos, observed conditions, and a clear scope of repair. We cannot promise coverage decisions, since your insurer and policy determine those, but we can make your claim easier to review.

Local Code Checklist for Houston Projects

We account for applicable local requirements, including wind uplift considerations, so repairs and re-roofs meet expectations. This is a checkpoint, not legal advice, and we recommend confirming requirements with your local permitting office.

Repair or Replace? How We Guide the Long-Term Choice

Our recommendation reflects the total cost of ownership, not the biggest job. If a repair is the right call, we say so.

Cost, Remaining Life, and Downtime Comparison

Localized repairs usually cost less and finish faster, but they make sense only if the rest of the system is sound. Older or widely saturated roofs may cost more to patch repeatedly than to replace. Actual costs and service life vary by roof type, condition, and building use.

TPO Overlay, Full Tear-Off, and Metal Panel Options

An overlay (a new membrane installed over the existing one) can be used on dry, stable roofs. A full tear-off is typical when insulation is wet. Metal panels suit some buildings. We also service EPDM and asphalt shingle systems.

Energy Performance and Warranty Terms

Reflective membranes like TPO can reduce cooling demand in Texas heat, though results vary by building. Warranty terms often depend on following manufacturer’s requirements, so we review them with you before work begins.

Work Schedules That Keep Your Doors Open

We stage materials, set safety zones, and can schedule off-hour work to limit disruption in multi-tenant and active facilities.

Schedule a No-Pressure Storm Damage Assessment

If a storm has hit your property, reach out to our team through our contact page. We will inspect the roof, document our findings, explain your options plainly, and work to minimize downtime.

We Are Here To Serve You

The Houston, TX area is our home and we love serving the community we’re a part of. When you work with Eagle Eye, you’re working with people who care about your business and its patrons!